Honda Error Code P1362: How to Fix It

Q: What causes Honda error code P1362?

P1362 is typically caused by a faulty TDC sensor, damaged wiring to the sensor, poor electrical connections, or incorrect sensor positioning. Less commonly, it can be caused by timing belt/chain issues or ECM problems.

Q: Can I drive with Honda code P1362?

You should not drive with P1362 as it can cause engine misfiring, poor performance, and potential engine damage. The TDC sensor is critical for proper ignition timing, so address this issue immediately.

Q: How much does it cost to fix P1362 on a Honda?

If the issue is just a bad TDC sensor, expect to pay $50-150 for the part plus 1-2 hours of labor ($100-200). Total cost typically ranges from $150-350 depending on your Honda model and local labor rates.

Q: Where is the TDC sensor located on Honda vehicles?

The TDC sensor is typically located on or near the timing belt cover, close to the crankshaft pulley. The exact location varies by Honda model and year, so consult your service manual for the precise location.

Q: What happens if I ignore Honda code P1362?

Ignoring P1362 can lead to severe engine misfiring, poor fuel economy, catalytic converter damage, and potentially serious engine damage due to incorrect ignition timing. Address this code immediately.

Abstract

Honda error code P1362 indicates that the Top Dead Center (TDC) sensor 1 is not sending a signal to the engine control module. This sensor is critical for proper engine timing and ignition, so this error can cause rough idling, misfiring, or prevent the engine from starting altogether.