Husqvarna Automower Error Code 28: How to Fix It

Q: What causes Husqvarna Automower error 28?

Error 28 is caused by a memory circuit problem on the main control board, typically due to component failure, water damage, power surges, or normal wear over time.

Q: Can I fix Automower error 28 myself?

You can try basic troubleshooting like power cycling and factory reset, but error 28 usually requires main board replacement which should be done by authorized service technicians.

Q: How much does it cost to fix error 28 on Husqvarna Automower?

Repair costs vary by model and warranty status, but main board replacement typically ranges from $200-500 including parts and labor at authorized service centers.

Q: Is Husqvarna Automower error 28 covered under warranty?

Error 28 may be covered under warranty if the mower is within the warranty period and the failure is not due to damage from water, impacts, or misuse.

Q: How long do Husqvarna Automower control boards last?

Main control boards typically last 5-7 years with proper maintenance and protection from moisture, though some may fail earlier due to environmental factors or manufacturing defects.

Abstract

Husqvarna Automower error code 28 indicates a memory circuit problem on the main board, which is a critical fault that prevents your mower from operating properly. This error typically means the mower's control board has experienced a hardware failure and cannot store or access essential operational data.