LG Dishwasher Error Code FE: How to Fix It

Q: Why does my LG dishwasher keep showing error code FE?

Error code FE typically recurs due to a faulty water inlet valve that won't close properly, damaged door seals allowing water to leak out, or a malfunctioning water level sensor. These issues cause the dishwasher to detect overflow conditions repeatedly.

Q: Can I still use my dishwasher with error code FE?

No, you should not use your dishwasher when it displays error code FE. This error indicates a potential flood risk, and the appliance will not operate normally until the underlying cause is fixed.

Q: How much does it cost to fix LG dishwasher error FE?

Repair costs vary depending on the cause. Door seal replacement typically costs $50-100, water inlet valve replacement ranges from $75-150, and control board replacement can cost $200-400. Labor costs are additional if hiring a professional.

Q: Will error code FE clear itself?

No, the FE error code will not clear itself. You must identify and fix the underlying cause (leaking seals, faulty inlet valve, or sensor issues) and then reset the dishwasher before normal operation can resume.

Q: How do I reset my LG dishwasher after fixing error FE?

To reset your LG dishwasher, press and hold the Start/Reset button for 3-5 seconds, or unplug the unit for 5 minutes then plug it back in. The error code should clear if the underlying problem has been resolved.

Abstract

The LG dishwasher error code FE indicates an overflow condition where too much water has been detected in the unit. This critical error causes the pump to run continuously to prevent flooding and requires immediate attention to avoid water damage.