Frigidaire Washer Error Code i30: How to Fix It

Q: Can I just reset my Frigidaire washer to clear error i30?

Resetting may clear the error temporarily, but if the leak isn't fixed, the code will return. Always find and fix the source of the leak first.

Q: Where is the leak sensor located on a Frigidaire washer?

The leak sensor is a float switch inside the bottom pan of the washer. You need to remove the front or bottom access panel to find it.

Q: How do I test the water inlet valve on my Frigidaire washer?

Disconnect power and water supply. Remove the valve and use a multimeter to test continuity across the coil terminals. A reading of 500-1500 ohms is normal. Also check for cracks or corrosion.

Q: Will error i30 cause my washer not to drain?

Yes, the leak detection system will stop the cycle and prevent draining to avoid further water release. Fixing the leak and resetting should restore normal operation.

Q: Why does my Frigidaire washer say i30 but no water on the floor?

The leak sensor can be triggered by a small amount of water that evaporates quickly, or by a faulty sensor. Check the bottom pan for any moisture and test the sensor if needed.

Abstract

Error code i30 on your Frigidaire washer means the leak detection system has been activated, usually due to a water leak under the machine. This safety feature pauses the cycle to prevent flooding. Most leaks can be traced to loose hoses, a clogged drain pump, or a faulty water inlet valve.